Dürr FD 366 at a glance

▪ Practical disinfectant for fast-acting disinfection of sensitive surfaces on invasive and non-invasive medical devices

in hospitals, private practices, and laboratories.

▪ Excellent compatibility with materials. Particularly suitable for sensitive surfaces, such as acrylic glass, plastics, and syn-

thetic leather coverings on treatment units.

▪ Exposure time in accordance with VAH only 1 minute.

▪ Broad spectrum of activity: bactericidal, tuberculocidal, levurocidal, with limited virucidal activity (enveloped viruses, including HBV, HCV, and HIV as well as non-enveloped noroviruses).

▪ Tested in accordance with current VAH methods and European standards.

▪ Tested in 4-field test in accordance with VAH and EN 16615.

▪ VAH list. Tested in accordance with EN 13727, EN 13624, EN 14348, EN 14476, EN 16615.

Alcohol-reduced, ready-to-use solution for disinfecting and cleaning especially sensitive surfaces of medical devices.

• Bactericidal incl. TB, yeasticidal, limited virucidal and effective against non-enveloped

• viruses (noro)

• Quick disinfectant effect

• For treatment units, ideal in combination with FD 360 artificial leather cleaner

• Tested material quality – recommended by leading unit manufacturers

Active substances: Alcohols, QAV

Also available as: Dürr FD 366 sensitive 100 wipes (20x30 cm) in dispenser box, 4 refill packs with 100 wipes (20x30cm), 50 top wipes (17,5x25cm)

General instructions

Disinfect the exterior surfaces of medical devices, such as dental curing lights, nozzles, handpieces, and contra-angle handpieces, prior to processing as required in accordance with the manufacturers‘ instructions. In the case of sensitive surfaces, test for compatibility in an inconspicuous place. Changes in product colour/odour may occur, especially when stored in sunlight. However, these changes in colour and/or odour have no impact on the disinfection of the product.

Manual processing of the dispenser and lid: Manually scrub and remove any deposits or residues. Thoroughly rinse the inside and outside of the dispenser, including the lid, with hot tap water (>55°C – Caution: risk of scalding!) and dry with a paper towel.

Then use a paper towel soaked with a fast-acting, alcohol-based disinfectant (e.g. FD 322 or FD 333) to completely wet and thoroughly disinfect the dispenser and lid. (Allow corresponding exposure time to elapse!) Make sure to dry the dispenser and lid completely.

Alternative automated processing: Process and dry the dispenser and lid in a chemothermal cleaning and disinfection system at up to 93°C.